Relaismodul Graupner 3968 switch and control the way you want it
With the relay module you have the possibility directly over one receiver output to switch a load. The receiver output must be programmed to level control (ON / OFF)
Receiver software version V7.XX)
It can be assigned to the switching channel one encoder (mc-16 to
mc-28 or mx-12 to mx-20/mz-18 and mz-24)
In addition, the mz-32 and mc-32 (version 2019) can also
digital switches can be programmed on the touch screen as a donor.
Both ON / OFF and FLASHING
The control LED on the board indicates the switching status. About the
four holes, the board can be installed in the model and bolted
become. The enclosed patch cable leads from the switching relay
to the receiver output. At the three-pole screw terminal
the consumer is connected.
In the middle is the entrance. Above it the opener, including the normally open contact.
If the LED is off, the opener is closed towards the entrance.
If the LED is lit, the opener is open towards the entrance. At the
Normally vice versa.
When controlling an engine (winch, seat posts, etc.) this can
be reversed in conjunction with two relay boards. There are
then two control channels on the receiver as well as two switches on the
Transmitter required. A polarity reversal via a 3-way switch
is not possible with the level control, because the channel only
ON / OFF switches, ie +/- 100%
de
en