Regler ULTRA CONTROL30A 2-6S BLHELI S Graupner S3081
The Race Copter Controller for 2-6S LiPo
The Graupner UltraControl 30 A Race BL Heli S is the ideal controller for all Multicopter, especially Racecopter, used in FPV Racing. The 30 A Race combines a compact design, low weight, fast reaction times and optimized settings for Racecopter.
The UltraControl 30 A has installed the Open Source BLHeli S software for standard servo, oneshot, multishot and D-shot. The controller uses the modern 50 MHz Silabs processors. The processor has a twice as high clock rate compared to its predecessors. This guarantees higher maximum speeds as well as precise timing at high speeds.
The power amplifier is housed in a 5 x 6 housing. The field effect transistors (FET) have an extremely low internal resistance (typically 1.5 mOhm). Special FET drivers ensure a more active freewheeling and better cooling of the output stage.
The ceramic capacitors used allow fast start-up times and guarantee high operating safety.
The controller has pre-activated the Damped Light mode. This allows a more precise flight behavior.
The UltraControl 30 A Race detects normal (PPM) receiver pulses, but also OneShot, Multishot or D-Shot. The controller and servo travel are already optimized for the GR-18 and the Racecopter settings. A 100 mm receiver cable is pre-installed.
The speed limit of the 30 A Race is 400,000 RPM with two-pole motors.
The 50 MHz Silabs processor of the 30 A controller can be updated and programmed using the Graupner update cable (No. 7168.6) and the included adapter.
Features
- Open source BL Heli S software
- 50 MHz Silabs processor
- High quality 5 x 6 FET power amplifiers with typical 1.5 mOhm
- Special FET drivers
- Ceramic and Tantalum capacitors, as well as suppressor diode for protection against overvoltages
- PPM receiver pulses, OneShot, Multishot and D-Shot software
- Servo settings and settings optimized for GR-18 and Race Copter
Specification Width [mm]: 18 mm
Weight incl. leads [g]: 17 g
Dimensions approx. : 40 x 18 x 7
Height [mm]: 7 mm
Pulse frequency [kHz]: 24 kHz
Weight [g]: 17 g
Dimensions with capacitor : 40 x 18 x 7 mm
Battery plug connection: Cable
Cell count, LiPo, Lilo, LiFe: 2 - 6S
Dimensions without cable: 40 x 18 x 7 mm
Overall length [mm]: 40 mm
Dimensions [LxWxH in mm]: 40 x 18 x 7 mm
Max. continous current [A]: 30 A
Motor connection: Lötanschluss
Operating voltage(V) language dependent: 7,4 - 22,8 V
Field of application: Copter
Brushless: Yes
Type: without BEC