Regler ULTRA CONTROL10A 1-2S BLHELI S Graupner S3079
The aircraft speed controller for 1-2S LiPo without BEC
The Graupner Ultra Control 10 A Race BL Heli S is the perfect speed controller for all multi-copters and race-copters with 1-2S LiPo but also especially suitable for indoor models with 1S. The 10 A Race combines a compact design, low weight, fast reaction times and optimized settings for race-copters.
The Ultra Control 10 A has the Open Source BLHeli S Software installed for standard servo pulse, Oneshot, Multishot and D-Shot 150, 300, 600. The aircraft ESC uses the modern 50 MHz Silabs processors. The processor has a clock rate two times faster than its predecessors. This grants higher maximum speeds as well as precise timing at high speeds.
The power amplifier is located in a 3.3 x 3.3 DFN package. The field effect transistors (FET) have a low internal resistance. Special FET drivers ensure a more active freewheeling and better cooling of the power amplifiers.
The ceramic and tantalum capacitors used allow fast start-up times and guarantee high operational safety.
The controller has pre-activated the Damped Light mode. This allows a more precise flight behavior.
The Ultra Control 10 A Race detects normal (PPM) receiver pulses but also OneShot, Multishot or D-Shot. The controller and the servo travel arealready optimized for the GR-18 and the race copter settings. A 100 mm receiver cable is pre-installed.
The speed limit of the 10 A Race is 400.000 RPM with two-pole motors.
The 50 MHz Silabs processor of the 10 A can be updated and programmed using the Graupner update cable (No. 7168.6) and the included adapter.
Features
- Open Source BL Heli S software
- 50 MHzSilabs processor
- High quality DFN 3.3x3.3 EP FET power amplifiers
- Special FET drivers
- Ceramic and Tantalum capacitors, as well as suppressor diode for protection against over-voltages
- PPM receiver pulse, OneShot, Multishot And D-Shot Software available
- Servo travel and settings optimized for Graupner receivers
Specification Width [mm]: 14 mm
Weight incl. leads [g]: 6 g
Weight excl. leads [g]: 2 g
Height [mm]: 7 mm
Pulse frequency [kHz]: 24 kHz
Battery plug connection: Cable
Cell count, LiPo, Lilo, LiFe: 1 - 2
Overall length [mm]: 27 mm
Dimensions [LxWxH in mm]: 27 x 14 x 7 mm
Max. continous current [A]: 10 A
Motor connection: Lötanschluss
Field of application: Copter, Indoor
Brushless: Yes
Type: without BEC