Schaltmodul 10A Graupner S8527
small switch , big action
With the switching module 10 A it is possible to switch a load directly via a receiver output. The receiver output must be programmed for level control (ON / OFF). (From receiver software version V7.XX, with mz-32 also possible with gyro receivers #33579 GR-18 with vario, #33583 GR-24PRO with Airplane-/Helisoftware >=2.04)
A switch (toggle switch) can be assigned to the switching channel (mc-16 to mc-28 or mx-12 to mx-20, mz-18 and mz-24)
For the mz-32 and mc-32 (version 2019), digital switches can also be programmed on the touch screen as encoders. Both ON / OFF and FLASHING
With the jumper it is possible to differentiate between supplying the load through the receiver power (jumper set) or external power supply. (Jumper pulled) For external power supply via X3 / X4, the jumper MUST be pulled, otherwise the receiver, the components connected to the receiver and the switching module will be damaged!
The unit (motor, LED, light bulb, etc.) is connected to X1 / X2. No cables are soldered to the board, so there is the possibility for different cable sizes and connector types.
You can attach the module with either double-sided tape or cable ties in the model. When mounting, make sure that the board does not bend and that the underside of the board does not touch any other components (risk of short circuit).
The supplied shrink tubing is pushed over the board after soldering the cables to X1-X4 and shrunk with a hot air blower. Output cable lengths and thicknesses can be used for X1-X4, depending on where the unit is located.
- Operating voltage 4,0 - 8,4V from receiver
- Switch current max. 10 A
- Switch voltage max. 20 V
- Dimensions 23 x 11 x 5 mm
- Weight < 2g
- Required control channels: 1x control or digital switch