ST Model Salto EP EDF ARTFAnother stunning innovation from ST models, this Salto aerobatic glider not only performs superbly as a foam glider in its own right, it also features a retracting EDF unit!
Inspired by the ST Model DG1000 this Salto has a retracting EDF unit pre-installed and ready to use. Using the supplied motor retraction controller, radio setup is easy and operation is even easier. When you open the throttle the first 10% on your TX the controller raises the fan opening the doors as it goes and then arms the ESC allowing you to fly as a powered glider. The second you close the throttle below the 10% mark the ESC is disarmed and the motor is retracted into the fuselage. You can also over-ride this using a 5th channel on a switch and keep the motor out for the whole flight if you choose.
The airframe itself features the clever design you expect from ST Models. Injection moulded in EPO and reinforced with carbon tube to ensure rigidity and strength. The design is interlocking and quick to assemble. The tailplanes are held on with two screws and the wings Twist & Lock to the fuselage and are retained by simple catches. Then simply connect the control wires to the horns with supplied screws. Thats it, 5 screws!
Simply install a suitable RX and TX, charge and fit a 3S 11.1v 1800-2100mAh li-Po to get going.
• 56mm retracting EDF unit
• Pre-programmed motor retraction & ESC controller.
• Tough EPO construction
• Easy wing attachment system
• No glue required
• Foam wheel to protect fuselage
|
Wingspan / Spannweite: | 1806mm |
Length / Länge: | 810mm |
Weight / Gewicht: | 880g (Approx.) |
Servos / Servos: | 4 (Inc.) |
Radio System / Fernsteuerung: | 4-5 Channel (Req.) |
Electric Motor / Elektromotor: | Brushless (Inc.) |
EDF Fan Diameter / Impeller Grösse: | 56mm 3-Blade (Inc.) |
Speed Controller / Drehzahlsteller: | 40A Brushless (Inc.) |
LiPo / LiPo Akku: | 3S 11.1v 1800-2100mAh (Rec.) |